Visonic KP-250 - Enabling; Disabling the Squawk Option

6. System Configuration
D-304269 KP-250 PG2 User’s Guide 43
11
You can select between:
"
by single ack " – an acknowledge signal from only a single telephone will stop the reporting process.
" by all ack " – an acknowledge signal from all telephones is required to stop the reporting process.
12
You can now, select other options, end this session – (see section A.1 and section A.2), or quit programming (see
section A.3).
B.13 Enabling / Disabling the Squawk Option
The PowerMaster system (and its wireless sirens) can be set to p
roduce a short "Squawk" of audible feedback to assist
you when you use your keyfob to arm (1 beep) and disarm (2 beeps) the PowerMaster system (operates in a similar
manner to a car alarm).
♦ Here you can enable / disable the Squawk.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table at
end of this section.
1.
SQUAWK
on
Enter the [USER SETTINGS] menu, select the [SQUAWK] option and press
.
1
SQUAWK
on



The display shows the currently selected setting.
2
2.
or Click the or button until the display reads the desired setting, for
example, "off" and press the
button to confirm.
SQUAWK
off
3.
SQUAWK
off



A "Happy Tune" ☺ sounds and The display confirms the saved setting.
3, 4
Additional Information (section B.13)
1
For detailed instructions on how to select User Settings – refer to section A.1 and section A.2.
2
a. The display shows the currently selected setting (indicated b
y a



symbol), for example, [ SQUAWK on ].
b. You can now enable (ON) or disable (OFF) the Squawk option using the or button.
3
The



sym
bol now appears next to the new selected option.
4
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).