5. Reviewing Troubles and Alarm Memory
D-304269 KP-250 PG2 User’s Guide 19
Trouble Indications
The trouble indications (illuminated TROUBLE indicator
and
flashing TRBL message) are cleared once you eliminate
the cause of trouble.
Fault What it means
1-WAY
The device functions but cannot "hear" the panel. The control panel cannot configure
or control the device. Battery consumption increases.
AC FAILURE
There is no power supplied to the device.
FIRE CLEAN
The fire detector must be cleaned
COMM. FAILURE
A message could not be sent to the monitoring station or to a private telephone (or a
message was sent but was not acknowledged)
CPU LOW BATTERY
The backup battery within the control panel is weak and must be replaced (see
PowerMaster-10/30 G2 Installer’s Guide, section 7.3, or, PowerMaster-33 G2
Installer’s Guide, section 5.2).
CPU TAMPER OPEN
The control panel was physically tampered with or its cover was opened, or it was
removed from wall.
GAS TROUBLE
Gas detector failure
GAS NET FAIL
The GSM communicator is not able to connect to the cellular network.
SYSTEM JAMM
A radio-frequency signal which is blocking all communication frequency channels
between the sensors and control panel is detected.
LINE FAILURE
There is a problem with the telephone line
LOW BATTERY
The battery of the indicated device is near the end of its useful life.
MISSING
A device or detector has not reported for some time to the control panel.
NOT NETWORKED
A device was not installed or not installed correctly, or, cannot establish
communication with the control panel after installation.
RSSI LOW
The GSM communicator has detected that GSM network signal is weak
SIREN AC FAILURE
There is no power to the siren
TAMPER FAILURE
The sensor has an open tamper
TROUBLE
The sensor reports trouble
SOAK TEST FAIL
Detector alarms when is Soak Test mode
To Next Page
Loading...
