APPENDIX D: Compliance with Standards
66 D-304269 KP-250 PG2 User’s Guide
APPENDIX
A
PP
ENDIX APPENDIX
APPENDIX D
DD
D:
: :
: Complian
ComplianComplian
Compliance with Standards
ce with Standardsce with Standards
ce with Standards
Designed to comply with Standards Eu
rope: EN 300220-1, EN 300220-2, EN300330, EN301489, EN60950,
EN50131-1, EN50131-3, EN50131-6.
The KP-250 PG2 is compatible with the RTTE requirements -
and EN50131-1 Grade 2 Class II.
USA: CFR 47 part 15
Canada: RSS 210
UK: This product is suitable for use in systems installed to conform to
PD6662:2010 at Grade 2 and environmental class 2. DD243 and BS8243.
Sweden: SSF 1014
RFID Tags: ISO-18000-2 (125 kHz)
The Power G peripheral devices have two- way communication functionality, providing additional benefits as described in the technical brochure.
Th
is functionality has not been tested to comply with the respective technical requirements and should therefore be considere
EN 50131-1 Security Grade
Grade 2
EN 50131-1 Environmental Class
Class 2
This device complies with FCC Rules Part 15 and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the mobile version of this device should be located at a distance
of at least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction
with any other antenna or transmitter.
The digital circuit of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference
by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
Changes or modifications not expressly approved by Visonic Ltd. could void the user's authority to operate the equipment.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased
it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your
supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
To Next Page
Loading...
