Visonic KP-250 - System Configuration; Entering the User Settings Menu & Selecting a Setting Option

6. System Configuration
20 D-304269 KP-250 PG2 User’s Guide
6
6
6
6.
..
.
System Configuration
System ConfigurationSystem Configuration
System Configuration
This chapter explains the user programming features of your
PowerMaster system using the KP-250 PG2 keypad.
To access the User Settings menus, a KP-250 PG2 keypad must first be enrolled in the system. For instructions on how
to enroll the KP-250 PG2 Keypad, refer to the KP-250 PG2 Installer’s Guide, section 11.4.
The Master User has access to all the User Settings menus, while the User has access only to the bypass menus (see
section B.4 in this chapter, which describes in detail the concept of User and Master User codes).
A.1 Entering the User Settings Menu & Selecting a Setti
ng Option
The following procedure describes how to enter and move within the User Settings menu.
Detailed descriptions of the User Settings options are provided at the end of the procedure.
To exit the User Settings menu – see section A.2.

1. You can enter the "USER SETTINGS" menu only when the system is disarmed.
2. Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table
at end of this section.
A. To Enter the USER SETTINGS Menu
1.
HH:MM READY
Make sure the system is disarmed and then press the button repeatedly on
the KP-250 PG2 until the display reads [USER SETTINGS].
1
2.
USER
SETTINGS
Press
PRESENT TAG OR
ENTER CODE: 

_
__
_ _
__
_ _
__
_ _
__
_
The screen will now prompt you to enter your user code or present your proximity
tag.
3.
CODE
Enter your User Code.
2
SET ZONE BYPASS
The display reads the first Setting option of the User Settings menu [SET ZONE
BYPASS].
3
B. To Select a Setting Option
4.
SET ZONE BYPASS
Click the or button until the display reads the desired setting option,
for example, "TIME & FORMAT".
or
5.
TIME & FORMAT
When the desired setting option appears on the display, press the button to
enter the setting process.
Continue to the selected
setting option in B.1 - B.16
The remainder of the procedures for the selected setting options is provided in
sections B.1 to B.16.