Visonic KP-250 - Page 23

6. System Configuration
D-304269 KP-250 PG2 User’s Guide 21
C. User Settings Options Menu
Click
until the display reads the desired setting option and then press .
SET ZONE BYPASS
Use to set the Zone Bypass Scheme i.e. to bypass (exclude) faulty or unsecured
("disturbed") zones, or to clear a bypassed zone (unbypass). For further details and
programming procedure see section B.1.
REVIEW BYPASS
Use to quickly review the Bypass Scheme i.e. which zones are bypassed. For further
details and reviewing procedure see section B.2.
RECALL BYPASS
Use to Recall the last used bypassed scheme for reuse in next arming period. For further
details and recalling procedure see section B.3.
USER CODES
Use to program your Master User secret access code and the seven codes of the other
users. For further details and programming procedure see section B.4.
DURESS ALARM
CODE 2580
Use to send a duress (ambush) alarm message to the Monitoring Station if you are
forced to disarm the system under violence or menace. For further details and
programming procedure see section B.5.
PROXIMITY TAGS
Use to add new Proximity Tags to or to delete Proximity Tags when lost. For further
details and programming procedure see section B.6.
KEYFOBS
Use to add new Keyfob Transmitters or to delete Keyfob Transmitters when lost. For
further details and programming procedure see section B.7.
TIME & FORMAT
Use to set the time clock to show the correct time and time format. For further details
and programming procedure see section B.8.
DATE & FORMAT
Use to set the calendar date to show the correct date and date format. For further details
and programming procedure see section B.9.
Additional Information (section A.1)
1
Display shown in disarm state when all zones are secured (00:00 or other digits show present time).
2
a. If you have not already changed your personal code number, use the default setting – 1111.
b. Master User has access to all User Settings options. Other users have access only to the Bypass options.
c. If you enter an invalid user code 5 times, the keypad will be automatically disabled for a pre-defined period
of time and the message WRONG PASSWORD will be displayed.
3
The bypass options will be displayed in the User Settings menu only if enabled by the installer. Otherwise, the
first User Settings option displayed will be [ USER CODES ].