Visonic KP-250 - Exiting the Event Log

9. Maintenance
58 D-304269 KP-250 PG2 User’s Guide
To read the event log, proceed as follows:
HH:MM READY
1.
PRESENT TAG OR
ENTER CODE:



2.
CODE
When the KP-250 PG2 display reads [PRESENT TAG OR ENTER CODE: ],
enter the current master user code or present your tag.
KP-250
LIST OF EVENTS
The "Happy Tune" will sound and the display will read [KP-250 LIST OF
EVENTS]. (see Important Note!)
3.
Click the button. The latest event will be shown.
CPU LOW BATTERY
12/04/11 15:14
The event is displayed on two rows, for example, "CPU LOW BATTERY" then
"12/04/11 15:14".
The display will be shown until clicking again to move to the next event or
until the event log times out (4 minutes).
F03 DISARM
15/03/11 08:37
4. Click the button as many times as necessary to read all the required data.
Important Note! Entering an incorrect code 5 times in a row will initiate a 30-
second penalty lockout of the keypad.
Attention: The system will not allow you to erase the event log. Only the installer
is authorized to view and perform this function.
Exiting the Event Log
1.
Click the button from anywhere within the event log.
The display will read [KP-250 <OK> TO EXIT].
KP-250
<OK> to Exit
2.
Click the button.
HH:MM READY
The system reverts to the normal operating mode.