EasyManua.ls Logo

Visonic KP-250 - B3. the Show Function; B4. Siren; B5. Partition Status Display

Visonic KP-250
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
APPENDIX B: Partitioning
D-304269 KP-250 PG2 User’s Guide 61
B3. The Show Function
The show function is enabled during single/all partition
(s)
status and displays information that is relevant to the selected
or all partitions.
Show All Partitions
In Ready mode press , the display will show information on all partitions. Press repeatedly to view
memory / status content.
Show Single Partition
In Ready mode, press
and then press the partition number. The display will show information relevant to the
selected partition. Press repeatedly to view memory / status content.
Note: After 5 seconds of no button press there will be a timeout and the display will revert to the all partition display.
B4. Siren
A partition is alarmed when receiving an event from an a
larmed device assigned to that partition. Alarmed devices do
not affect partitions to which they are not assigned. A siren is common to all partitions; therefore, an alarm from one or
more partitions will activate the siren.
Siren Activity
The siren will be activated when receiving an event from an alarmed device.
Overlapping siren activations from different partitions w
ill not cause the duration of the siren to be extended.
When the siren sounds, it will not stop until all alarmed partitions are disarmed. However if the siren is active due to
an alarm from a common area zone, and one of the partitions assigned to this area disarms the system, the siren will
also stop. In case that the alarm is initiated from a common area but continues with zones that are not assigned to a
common area, the siren will not stop until all partitions assigned to the alarmed zones are disarmed.
In case of a fire in partition 1 and a burglary in partition 2, the siren will sound FIRE. When partition 1 is
disarmed, the siren will sound BURGLAR for the remainder of the siren timeout period.
B5. Partition Status display
Partitions status is indicated in the following manner:
P1:
X P2:X P3:X
Each X value indicates a different partition state, as follows:
R
Ready
N
Not ready
A
Away
H
Home
E
Exit delay
D
Entry delay
-
Not used

Table of Contents

Related product manuals