6. System Configuration
D-304269 KP-250 PG2 User’s Guide 37
B.10 Enabling / Disabling Auto-Arming
The PowerMaster system can be programmed to automatically
a
rm itself on a daily basis at a predetermined time. This
feature is useful especially in commercial applications, such as in stores, to ensure that the system is always armed
and without having to assign security codes to employees.
♦ Here you can enable (activate) and disable (stop) the Auto-Arming. To set the Auto-Arming time – see section
B.11.
♦ Auto-arming can arm a "NOT READY" system only if forced arming is enabled by the installer while programming
your system.
Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table at
end of this section.
1.
AUTO-ARM
enable
Enter the [USER SETTINGS] menu, select the [AUTO-ARM] option and press
.
1
AUTO-ARM
enable
The display shows the currently selected setting.
2
2.
or Click the or button until the display reads the desired setting, for
example, [disable autoarm] and press to confirm.
AUTO-ARM
disable
3.
AUTO-ARM
disable
A "Happy Tune" ☺ sounds. The display confirms the saved setting.
3
☺
B.11 Setting the Auto-Arming Time
♦ Here you can program the exact time of the Auto-Arming.
1.
AUTO-ARM TIME
12:00
Enter the [USER SETTINGS] menu, select the [AUTO-ARM TIME] option and
press .
1
AUTO-ARM TIME
12:00
The display shows the current setting of the Auto-Arm Time. At the blinking cursor
position, enter the correct time, for example, “8:30”, using the numerical keypad.
4
3.
When you are satisfied with the setting, press to confirm.
AUTO-ARM TIME
08:30
A "Happy Tune" ☺ sounds. The display confirms the saved time, then returns to
the User Settings menu, step 1.
5, 6
☺ Return to step 1
To Next Page
Loading...
