VisorJet VJS-B620-2-LPR - Page 3

7 Transportation ................................................... Ошибка! Закладка не определена.
7.1 The product must be transported in packaging at an atmospheric pressure of at
least 60 kPa (450 mm Hg), at an ambient temperature of -25° C to +50° C.. . Ошибка!
Закладка не определена.
7.2 When transporting the product, the requirements of the handling signs applied
to the packaging must be observed ..................... Ошибка! Закладка не определена.
7.3 During transportation, the packaging with the product must be securely fastened
to the means of transportation.. ........................... Ошибка! Закладка не определена.
7.4 The climatic conditions for transportation in containers .... Ошибка! Закладка не
определена.
7.5 Сargo handling operation must be carried out in compliance with safety
regulations.. ......................................................... Ошибка! Закладка не определена.
7.6 After transportation in below-freezing temperatures, the product will be ready
for operation within 1 hour at temperatures down to -50 ° C. .. Ошибка! Закладка не
определена.
8 8 Recycling information .................................... Ошибка! Закладка не определена.
8.1 The product does not contain elements that are hazardous to the environment,
therefore no special measures are required for the disposal.. ... Ошибка! Закладка не
определена.
8.2 The amount of nonferrous metals and precious materials contained in imported
components is determined based on actual data obtained during disposal in
operating organizations. ...................................... Ошибка! Закладка не определена.
Appendix A List of accepted abbreviations ............................................................48
Appendix B Product web interface .........................................................................49
B.1 Login to the web interface ...................................................................................... 49
B.2 Setting the parameters of the product ..................................................................... 50
Appendix C Installation recommendation .............................................................92
C.1 Mounting the VisorJet Smart Bullet Series, Models VJS-B620-2-LPR, VJS-
B620-2, VJS-B621-2, VJS-B620-5, VJS-B621-5......................................................... 92
C.2 Mounting the VisorJet Smart Bullet Series, Model VJS-B622-2-LPR. ................. 94
C.3 Installation of the VisorJet Smart Dome series, models VJS-D620-2, VJS-
D621-2, VJS-D620-5, VJS-D621-5. ................... Ошибка! Закладка не определена.
C.4 Mounting the VisorJet Smart Bullet mini Series, Models VJS-B603-2, VJS-
B603-5........................................................................................................................... 98