37
ВАРШ.201219.009РЭ
3.3.1.1 When preparing the product for operation, the safety measures specified in clause 3.5.1
should be observed.
3.3.2 Scope and sequence of external inspection
3.3.2.1 During the external inspection of the product before switching on, make sure that there
are no external damages.
3.3.3 Installation sequence
3.3.3.1 The product is installed by the buyer himself.
3.3.3.2 The product is installed in the following sequence:
1) attach the product to the installation site, at the same time you can choose any position of
the bracket that satisfies the method of fixing the cable;
2) mark the attachment points;
3) drill a hole in which the dowels should be installed;
4) fix the product on the surface with self-tapping screws;
5) connect the product to the video surveillance system by switching the network cable to the
RJ-45 port;
6) connect the product to the power supply using a network cable, if the counterpart of the
cable is connected to the PoE injector. If power supply using PoE technology is not possible,
then the product must be powered from an external power supply 12V ± 0.25V (not included
in the delivery set);
7) point the product to the video surveillance object;
8) if the product is equipped with a motorized varifocal lens, adjust the viewing angle directly
at the installation site. To do this, you need to use the web interface.
3.4 Prestarting procedures
3.4.1 Preparing the product for operation before electric power supply includes:
- checking the reliability of fixing the product in place;
- checking the reliability and correctness of connecting all cables, as well as the absence
of damage to the cables;
To Next Page
Loading...