41
ВАРШ.201219.009РЭ
4.4 Function check of the product
Function check of the product is carried out by an employee of the operating company
according to the following method:
1) connect the product to power supply and Ethernet;
2) make sure that the power indicator located on the RJ-45 connector is blinking green. If
the connector is hidden among communications (for example, in the ceiling), then go to step 3);
3) open the web interface of the product on the display device and log in;
4) set the required settings for the video stream(s);
5) save the settings;
6) make sure the video data occurs in the web interface.
The product is considered to be operational if the settings are adjusted and saved, and the
video stream is broadcast in real time in the product web interface.
To Next Page
Loading...