38
ВАРШ.201219.009РЭ
- holding for 1 hour to heat the device if it was transported or stored at negative
temperatures (up to -50° С).
3.4.2 Switching sequence and functional check
3.4.2.1 Before turning on the product, perform the actions described in clause 3.3 (Preparation
for use).
3.4.2.2 The power supply to the product starts immediately after connecting the power cables
to the DC connector or to the RJ-45 connector if the device is powered using a PoE injector.
3.4.2.3 Malfunctions detected during the start-up process, as well as if it is impossible to
eliminate the malfunctions described in clause 5.3, are the basis for transferring the product for repair.
3.4.3 Shutdown sequence
3.4.3.1 To cut off the power supply to the product, pull out the wire from the DC connector
or from the RJ-45 connector if it is used to supply power.
3.5 Product use
3.5.1 Security measures
3.5.1.1 Operation of the product should be carried out by engineering and technical personnel
with special training in the field of computer technology.
3.5.1.2 When equipping the workplace, preparing for work and operating the product, it is
necessary to comply with safety requirements when working on installations with voltages up to 1000
V.
3.5.1.3 The following rules should be observed, when using the product:
- check the correct function and operativeness of the product before starting work, as indicated
in clause 3.4.2;
- turn on and off the product as indicated in clause 3.4.2;
3.5.2 Using
3.5.2.1 Prepare the product for use in accordance with clause 3.3 and turn on the product as
indicated in clause 3.4.2
3.5.2.2 The start-up of the product is carried out automatically after power supply without
intervention of the service personnel.
3.5.2.3 The product has a static IP address 192.168.5.190, by which it can be found on the
network.
To Next Page
Loading...