Vivint SmartHome ELEMENT - Page 14

14
Battery Powered Installation
Installfour(4)AAalkalinebatteriesfollowingthemarkedpolarityinthebatterycom-
partments.Insertthebatterynegativeendrstagainstthespring,thenpushtheposi-
tiveendin.
Vivint Element Installation Guide
Wiring
Reconnecting Power to HVAC System
Withallthewiresconnectedandtheunitattachedtothewall,itistimetoturnthe
furnaceand/orairhandlerpowerbackon.Reconnectthepoweratthebreakeryou
usedtoswitchito.TheThermostatwillpower-upintheSetupmode.
YourThermostatisnotyetconguredtooperateyourHVACsystem.Youmustnow
connectyourthermostattoaZ-WaveNetworkandconguretheHVACandHeat
Sourcesettings.
Proceed to Setup Section
Installing batteries