Vivint SmartHome ELEMENT - Installer Settings

50
Installer Settings
InstallersettingscontrolthefollowingThermostatfunctions:
EQUIPMENT:heating,cooling,humiditycontrol,andfanbehavior
TheEquipmentsettingsmenuistypicallyusedduringinstallationoftheThermostat.
Theoptionsinthismenuenableyoutosettheheating,coolingandhumiditycontrol.
NETWORK:theThermostat’sconnectiontoaZ-WaveNetwork
CALIBRATE: Osetstheunit’stemperaturedisplay
CYCLING: Thisfeatureenablesyoutosettheacceptablevarianceintemperature
betweentheThermostat’ssettingandthecurrentroomtemperaturebeforethe
heatingorcoolingsystemwillturnon.TheCyclingrangecanbefrom0.5to4.0F
(.25to2C).Forexample,ifCyclingissetto2.0°FandtheThermostatissetto70°F
targettemperature,theheatcyclewillstartwhentheroomtemperaturedropsto68°F.
Similarly,thecoolingsystemwillstartwhentheroomtemperatureincreasesto72°F.
TheHVACrunsuntiltheroomreachesthetargettemperature,andthenshutso.
STAGING:Usedformultiplestagesystemsonly.Stagingisthenumberofdegrees
betweentheroomtemperatureandthetargettemperatureatwhichthenextstagein
multi-stagesystemswillengagetobringtheroomtemperaturebacktothetarget.
Thedefaultis2°F.Theprogrammablerangeis2°Fto6°F(1°-3°C).
RESET:resettingtheThermostat’ssettingstofactorydefaults.
Besuretoturnthethermostatoperatingmode
toOFFbeforechangingHVACsetup
CAUTION
WARNING
TogetintoInstallerSettings,fromtheHomeScreen,pressandholdtheSIDEbutton
forthree(3)secondstoaccesstheSETTINGSmenu.
UsetheUP/DNarrowstoselecttheINSTALLERSETTINGS.Pressthesidebutton.
UsetheUP/DNarrowstoselectthedesiredinstallersetting.
Vivint Element Installation Guide
Customization