6
Vivint Element Installation Guide
Getting Started
Tools Needed
Small Phillips screwdriver
Level
To avoid electrical shock and to prevent damage to the furnace and thermostat, disconnect
the power supply before installing or servicing the thermostat or any part of the HVAC
system. This can be done at the circuit breaker labeled either furnace or air handler.
• Do not turn power back on until work is complete.
• Do not short (jumper) across electric terminals at the control on the furnace or air
conditioner to test the system. This can damage the thermostat.
• Your thermostat is a precise instrument. Handle it with care.
• All wiring must conform to local codes and ordinances.
• This thermostat is designed for use with 4AA alkaline batteries and/or 24-volt AC C
wire (or a 12- 24 AC or DC source) or millivolt gas systems. Each thermostat relay load
should be limited to 1.0 amp; higher amperage can cause damage to the thermostat.
CAUTION
To Next Page
Loading...
