DLP Projector – User’s Manual
– 37 –
Installation II Menu
Press the
MENU
button to open the
OSD
menu. Press the cursor ◄► button to move to the
Installa-
tion II
menu. Press the cursor ▲▼ button to move up and down in the Installation II menu.
I
TEM
D
ESCRIPTION
Auto Source Press the cursor ◄► button to enable or disable automatic source detection. (Range: On ~ Off)
Auto Power Off
(min.)
Press the cursor ◄► button to enable or disable automatic shutdown of lamp when no signal.
Auto Power On Press the cursor ◄► button to enable or disable automatic power On when AC power is supplied.
Fan Speed
Press the cursor ◄► button to toggle between Normal and High fan speeds.
Note: We recommend selecting high speed in high temperatures, high humidity, or high
altitude areas.
Lamp Mode
Press the cursor ◄► button to select the lamp mode for higher brightness or lower brightness
to save lamp life.
Advanced Press (Enter) / ► to enter the Advanced menu. See Advanced Feature on page 38.
Factory Reset Press (Enter) / ►
to reset all items to factory preset values.
Status Press (Enter) / ►
to enter the Status menu. See page 45 for more information on Status.
To Next Page
Loading...
Need help?
General
