VIVOTEK
10 - User's Manual
Hardware Reset
The reset button is used to reset the system or restore the factory default settings�
Sometimes resetting the system can return the camera to normal operation� If the system
problems remain after reset, restore the factory settings and install again�
Reset: Press and release the reset button� Wait for the Network Camera to reboot�
Restore: Press and hold the recessed reset button until the status LED rapidly blinks� Note
that all settings will be restored to factory default� Upon successful restore, the status LED
will blink green and red during normal operation�
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC of 8, 16, 32GB, or 64GB
capacity SD cards�
Reset Button
To Next Page
Loading...
Need help?
General
