Digidrive V2
User Manual
19
7.1………………………………….Minimum System Requirements
x Windows XP (with service pack 2), 7 or Mac OSX 10.5.8
or higher.
x USB or Ethernet port for connecting the Digidrive V2 to
the PC.
x Pentium 4 or higher
7.2………………………………………..…………Installing Live Link
Windows:
x Insert the included CD into the PC.
x Follow the instructions on the Setup Wizard carefully.
x Once the installation has finished, close the Setup
Wizard and remove the CD to begin.
Mac OSX:
x Insert the included CD into the PC
x Double click on the disk on the desktop to open the files
and open Void_DSPControl.mpkg
x Follow the instructions in the Setup Wizard.
x When the installation has finished, eject the CD.
7.3…..………………………………….Connecting the Digidrive V2
The Digidrive V2 can be connected to a PC via USB or Ethernet
network. Connection via USB requires the provided USB cable to be
plugged into the front of the Digidrive V2, and any USB port on the
PC. When connecting the Digidrive via Ethernet to the PC, an IP
address is required for communication between the device and the
PC. So, connecting the Digidrive V2 to the computers network
router will assign an IP address automatically through the networks
DHCP. This configuration is useful for installations, where there will
be more than one device controlling the system, as users are able to
connect the devices to a network and control each of them
separately from one PC, connected to the network by Ethernet or
wirelessly.
To Next Page
Loading...
Need help?
General
