Model DMTC22KW
Domestic Charger AC 22kW
3.2. Security Requirements
→ Eye protection with appropriate glasses (especially when using a drill).
→ During installation, be sure to avoid direct connections, with power distribution
cables with additional protection.
→ Always make sure that the power is cut off during the installation process.
→ Use appropriate tools for each role.
3.3. Energy supply
The DMTC22KW Charger must be connected directly to the customer's distribution
board for better performance and for safety reasons. The equipment requires a three-
phase or single-phase connection. A normal domestic or small connection may not be
sufficient. Contact your electricity distributor for more information.
The dimensioning of the charger input power line must be checked by a qualified
technician. It is important to note that several factors, such as the cable length
between the switchboard and the charging device, the maximum output current of the
charging device can affect the selected cable.
The technical data section provides nominal settings taken from the factory with the
supply of the maximum output current from the charger. If the current of the power
supply is less than the maximum output current, it may be necessary to adjust the
rated current to a lower value. For more information, refer to the detailed instructions
provided in the operation section.
Depending on the model, the recommended value may be different. Please check the
respective recommendation for the model purchased.
To Next Page
Loading...