Volt-E DMTC22KW - Ethernet Connectivity - Wi-Fi

Model DMTC22KW
Domestic Charger AC 22kW
37
→ Disconnect the network cable - Disconnect the RJ45 network cable from the
Android controller;
→ Connect to your network - Connect the network cable you want to the Ethernet
terminal of the Android controller;
→ Android secret menu - is described in section 6.3. of this manual, how to open the
Android secret menu, to access its internal settings;
→ Authenticate yourself - Put the code by default, or the code you defined to open
the menus;
→ Android Settings – Choose the Option Android Settings;
→ Menu Wireless & Networks – Choose the menu, Wireless & Networks;
→ Enable Wi-Fi – Ensures that the Wi-Fi network interface is OFF;
→ Restart the equipment – Physically restart the equipment to ensure that it starts up
correctly with the ChargeMonitorApplication application.
6.7. Conectividade Ethernet Connectivity Wi-Fi
When necessary, it is possible to connect the equipment to a local network through a
wireless network. The steps necessary to establish Wi-Fi connectivity are described
below.
→ Secret Menu Android – is described in section 6.3. of this manual, how to open the
Android secret menu, to access its internal settings.