Volt-E DMTC22KW - Page 21

Model DMTC22KW
Domestic Charger AC 22kW
16
→ The charger must NOT be installed in potentially explosive environments;
→ Install the Charger so that it is not in the direct flow of pedestrians and so
that no one can trip over the charging cables and that the cables do not cover or cross
pedestrian and motorized traffic;
→ Do not install the charger in places where it is exposed to ammonia or
ammonia gas (for example stables);
→ The mounting surface must be sufficiently stable to withstand mechanical
forces;
→ Do not install the charger in places where falling objects may damage the
device (for example, ladders or overhanging car tires);
→ The equipment must not be exposed to direct spray water (for example,
adjacent manual washing installation, high pressure cleaner, garden hose);
→ The equipment must be protected against direct rain, as much as possible,
to avoid freezing, hail or similar damage;
→ It is important to observe the permitted environmental conditions;
→ It is recommended not to expose this equipment to high temperatures, dust,
corrosive vapors, combustible materials or explosive gases;
→ Select a dry, well-ventilated place;
→ To reduce the risk of fire, install the charger on a concrete surface;
→ If possible, the device should be mounted protected from direct sunlight;
→ To comply with the instructions above, Volt-E recommends that the location
where the charger is installed is fully covered;