43
FUNCTION BUTTONS7.
All parameters and extra functions can be set using the function buttons.
Due to the large number of functions, the functions have been assigned subfunctions.
The subfunctions are activated via pressing of the buttons and holding down for approx. 1 s.
Always press the EXIT button to deactivate functions.
HOLD / PEAK HOLD / > Normal mode (press quickly):•
In STORE mode:
Switch between “Delete all values” and “Continue at next free memory
location”.
EXIT / LIGHT Normal mode (press quickly):•
Deactivate all active extra functions.
Subfunction (press and hold for 1 s):•
Switch on the display backlight at level 1.
Press again quickly to switch to level 2 and again to switch off the
backlight.
Setup function (press quickly):•
Exit the setup menu.
MAXMIN / SEND / - Normal mode (press quickly):•
The MAX and MIN values are shown in the subdisplays.
The current measured value is shown in the main display.
In RECALL mode:
Manually read out the data from the previous memory location.
In STORE mode:
Each time this is pressed, the automatic measurement interval is
decreased by one second (S).
Subfunction (press and hold for 1 s):•
Start transmission of current measured values.
The measured values are transmitted “online” to the interface and can be
processed further by the software.
Setup function (press quickly):•
Decrease the current parameter.
To Next Page
Loading...
Need help?
General
