86
Bringing out of storage
1. Remove any protective cover over the engine, air
intake and exhaust pipe.
2. Remove any external inhibitors using white spirit.
3. Close the drain cocks and fit the drain plugs. Fit
the seawater pump impeller using a rotating
movement:
TAMD63 – clockwise.
TAMD71 and TAMD72 – counterclockwise.
Fill the freshwater system if the coolant has been
drained. See “Filling with coolant” on page 55.
For coolant, see page 20.
4. If necessary, fill the engine with lubricating oil of
the correct quality. Fit a new oil filter if this has
not been done when changing the oil during in-
hibiting. Check the oil level in the reverse gear.
5. Check the batteries as described on page 67.
Connect the batteries.
6. Fit new fuel filters and vent the fuel system as
described on pages 49–51.
7. Open the sea cock. Start the engine (see “Oper-
ation”) and warm the engine up at a fast idle be-
fore loading the engine.
8. Check for any leaks of oil, fuel or cooling water.
To Next Page
Loading...
Need help?
General
