Maintenance schedule
The description applies generally for all engines unless otherwise stated.
If longer oil change intervals are required than those stated below the oil’s condition
must be tested regularly by the oil manufacturer.
The time intervals are guides which apply to normal operating conditions. For new or
reconditioned engines see under the heading “Running-in” on page 4.
All operations in the maintenance schedule with the exception of points 17 and 32 must
be carried out at least once per year even if the operating time in the schedule has not
been reached. Operations 17 and 32 must be carried out at least once every other year.
NOTE! Always turn the engine off before starting service procedures (except
operation 16)!
50 Hrs
100 Hrs
250 Hrs
500 Hrs
1000 Hrs
2000 Hrs
* Note: Special recommendations apply for new or reconditioned
engines. See instructions “Running-in” on page 4.
TAMD63
TAMD71, TAMD72
45
45
46
46
–
VDS engine oil or CD or CE as per API system. Drain or pump out oil while engine
is hot.
WARNING! Hot oil can cause burns.
Lubricate gasket and screw on new filter by hand. Tighten by 3/4 turn once gasket
is tight. Top up oil, start, check for leaks. Stop engine and check oil level.
Fill up with oil. Quality: Use CD, CE or CC engine oil. Only single grade lubricating
oil may be used in the reverse gears. For quality, see “Technical Data”. Check oil
level. Note: Marks on dipstick apply at operating temperature (engine idling and
control in neutral).
Remove plug and oil screen. Clean screen and refit parts. Start engine (after filling
with oil) and check for leaks.
Lubricate gasket and screw on new filter by hand. Tighten by 3/4 turn once gasket
is tight. Top up oil. Start, check for leaks. Check oil level (point 3 above).
●
1)
●
2)
●*
●*
●
1. Engine oil change.
Note: See table on page 31 for ratio of
oil quality to replacement interval.
1) TAMD63 and TAMD72.
2) TAMD71.
2. Replace oil filter (1) and
by-pass filter if fitted (2)
at every other oil
change.
3. Change oil in reverse
gear.
4. MPM reverse gear:
Remove and clean
reverse gear oil screen.
5. Replace oil filter in
reverse gear MPM IRM
301A.
No. Action Instructions Info.
pge.
To Next Page
Loading...