Placement and Mounting of Hull
Plug, Triple Installation
NOTICE! The illustration shows a hull mold.
Mark
out a straight line parallel to the keel at a distance
(A), which is governed by hull bottom angle (α=bottom
angle)
After installation, the distance between the upper gear case center must be at least 1200 mm (47.2") and max
1900 mm (74.8").
At a distance of 1400 mm (55.1"), the following applies:
Distance (A) from the keel to the plug cen-
terline at varying bottom angles
Bottom angle Distance
(β) (A) mm (in.)
5°
6°
7°
8°
9°
10°
11°
12°
13°
14°
15°
16°
17°
18°
19°
20°
21°
22°
23°
24°
1442 (56.8)
1451 (57.1)
1461 (57.5)
1472 (58.0)
1483 (58.4)
1495 (58.8)
1507 (59.3)
1519 (59.8)
1533 (60.3)
1546 (60.9)
1561 (61.4)
1575 (62.0)
1591 (62.6)
1607 (63.3)
1624 (63.9)
1641 (64.6)
1659 (65.3)
1678 (66.0)
1697 (66.8)
1717 (67.6)
Installation, Volvo Penta IPS
66 47704162 10-2014 © AB VOLVO PENTA
To Next Page
Loading...
