IMPACT
®
4000
54 55
COMPLIANCE
United States
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Contains FCC ID: T7V1760A
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Canada
CAN ICES-3B/NMB-3B
Contains IC: 216Q-1760A
Australia and New Zealand
Japan
Class B ITE
Translation:
This is a Class B product based on the standard of the
VCCI Council. If this is used near a radio or television
receiver in a domestic environment, it may cause radio
interference. Install and use the equipment according
to the instruction manual.
To Next Page
Loading...
