IMPACT
®
4000
16 17
MOUNTING
Once your Impact
®
4000 has been calibrated it can be
mounted to your weapon. Prior to mounting the laser
rangefinder ensure your riflescope is mounted and
zeroed to your desired zero distance.
1. Mount your picatinny diving board mount or
picatinny accessory rail and tighten to the
manufacturer’s torque specifications using a
torque wrench.
2. Place the Impact
®
4000 Picatinny Mount on
the rail and position it so its placement does not
interfere with the adjustment of the turrets.
3. Using the provided 1/2" Nut Diver Tool, tighten the
1/2" Lug Nuts to 45 in-lbs. Using a torque wrench
is recommended if available.
Note: If the Impact
®
4000 is mounted on the side of the gun,
the screen with auto-rotate accordingly.
The screen will read “Success” if the compass has
successfully calibrated. If the screens reads “Fail - Try
Again”, press the “Measure” button to restart the
calibration and repeat this process until the Impact
®
4000 is successfully calibrated.
To Next Page
Loading...
Need help?
General
