Vorwerk KOBOLD VB100 User Manual (English)

Other manuals for Vorwerk KOBOLD VB100

Questions and Answers:

J
Jay SmithSep 6, 2025
Why won't my Vorwerk Ultrasonic Jewelry Cleaner turn on?
- S
  Stacey AndersonSep 6, 2025
  Your Vorwerk Ultrasonic Jewelry Cleaner might not be turning on for several reasons. It could be in transport mode (as delivered), so try charging it. The battery pack might be empty, so charging it is recommended. Ensure the charger is correctly connected; a pulsating indicator confirms charging. Also, verify the battery pack is correctly inserted. Finally, disconnect the cleaner from the charger, as it won't start while connected.
T
Thomas WellsSep 7, 2025
What to do if the LED display lights up yellow on my Vorwerk Ultrasonic Jewelry Cleaner?
- M
  Mr. Chris CamposSep 8, 2025
  If the LED display on your Vorwerk Ultrasonic Jewelry Cleaner lights up yellow, it could be due to several reasons: the filter bag might be full, so you should insert a new one; the item you are cleaning might be too dense, so try cleaning a different item and check the LED display again; or the suction channels may be blocked, so you should check and clean them.
F
Felicia WatersSep 9, 2025
Why is my Vorwerk Ultrasonic Jewelry Cleaner Kobold electric brush so loud?
- K
  Kurt HawkinsSep 9, 2025
  If your Vorwerk Ultrasonic Jewelry Cleaner's electric brush is too loud, consider these possibilities: the roller brushes might not be correctly inserted, so check their placement; non-original Kobold accessories could cause noise and damage, so use only original Kobold roller brushes; or an object might be stuck in the roller brush area, so remove any obstructions.
K
Keith YoungSep 12, 2025
Why is the LED display flashing red on my Vorwerk Ultrasonic Jewelry Cleaner?
- J
  jfrazierSep 12, 2025
  The LED display on your Vorwerk Ultrasonic Jewelry Cleaner might flash red due to high temperatures slowing down the charging process. Avoid charging the device in direct sunlight. Charging may also take longer after intensive use or at high temperatures. The charging process can be accelerated by removing the battery pack from the device and charging it directly on the AC charger.
W
William RamirezSep 12, 2025
How to fix a Vorwerk Ultrasonic Jewelry Cleaner electric brush that is not vacuuming properly?
- T
  Tyler AdamsSep 12, 2025
  If the electric brush on your Vorwerk Ultrasonic Jewelry Cleaner isn't vacuuming properly, the suction duct of the electric brush may be blocked. Open the inspection flap on the underside of the electric brush, remove the blockage, and then put the inspection flap back on.
C
Christopher RobertsSep 14, 2025
What to do if my Vorwerk Ultrasonic Jewelry Cleaner Kobold electric brush switches off and the LEDs flash red?
- A
  Adam SimonSep 14, 2025
  If the Kobold electric brush on your Vorwerk Ultrasonic Jewelry Cleaner switches off and the LEDs flash red, a vacuumed object or threads may be blocking the brushes. Here's what to do: * Switch off the cleaner and disconnect the electric brush. * Remove any obstructing objects. * Cut and remove any threads blocking the brushes. * If the carpet is too dense, briefly lift the electric brush, place it on a hard floor, switch to ‘Brush off’ mode, or switch the cleaner to the ‘soft’ setting.