Getting started
10
Wall-mount to tabletop installation
To change the telephone base from the wall-mount position to tabletop
position, follow the steps below.
Unplug the large end of the power adapter from the electrical outlet.
Unplug the small end of the power adapter from the POWER jack on the
back of the telephone base.
Slide the telephone base upwards, then pull it away from the mounting
studs.
1.
2.
Unplug the telephone line cord from the telephone wall jack and the back
of the telephone base. Lift the handset and place it aside.
Hold the telephone base with both hands. Press on the outer tabs as shown
below to release the mounting bracket. Lift the mounting bracket away.
3.
4.
Wall-mount position
Outer tabs
To Next Page
Loading...
