Getting started
11
Switch hook
Handset tab
Remove the telephone line cord from the slots of the mounting bracket.
Remove the telephone line cord from the mounting bracket. Untie the
bundled telephone line cord.
Rotate the mounting bracket 180 degrees.
5.
6.
Insert the center tabs of the mounting bracket in slots and . Snap the
outer tabs of the mounting bracket in slots and .
7.
Hold down the switch hook on the telephone base, then slide the handset
tab upwards to remove it from the slot. Rotate the handset tab 180
degrees. Push the handset tab down into the grooves so it clicks into
position.
8.
Use slots , , and for
the tabletop-mount position.
Use slots , , and for
the wall-mount position.
Center tabs
To Next Page
Loading...
