VTech CS6124 User Manual

14
Telephone operation
Call waiting
When you subscribe to call waiting service from your telephone service
provider, you hear an alert tone if there is an incoming call while you are on
another call.
Press
/FLASH to put the current call on hold and take
the new call.
Press
/FLASH at any time to switch back and forth
between calls.
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer:
Press OFF/
CANCEL or MUTE/DELETE and
Ringer muted displays.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call. This is useful if you need to send touch-tone
signals to access your telephone banking or long distance services.
During a call, press
TONE .
Use the dialing keys to enter the relevant number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end the
call.
Find handset
7UGVJKUHGCVWTGVQſPFU[UVGOJCPFUGVU
To start paging:
Press /FIND HANDSET on the telephone base when
the telephone is not in use.
All idle system handset(s) ring and
**
Paging
**
ƀCUJGUQPVJGUETGGPHQTUGEQPFU
To end paging:
Press
/FIND HANDSET again on the telephone base.
-OR-
Press
/FLASH or any of the dialing keys (0-9, TONE
or #) on the handset to stop the paging tone.
•
•
•
1.
2.
3.
1.
2.
•
•
CANCEL
Ringer muted
10:15
PM 12/25

VTech CS6124 Specifications

Frequency and Channels

transmit frequency handset	1921.536-1928.448 MHz
transmit frequency telephone base	1921.536-1928.448 MHz
channels	5

Power Requirements

handset battery	2.4V Ni-MH battery
telephone base power	6V AC @ 300mA
charger power	6V AC @300mA

Memory

handset directory memory locations	30 memory locations
handset directory memory capacity	up to 30 digits and 15 characters
handset call log memory locations	30 memory locations