VTech CS6124 - Announcement; Record Own Announcement

28
Answering system settings
Recording time
You can set the recording time for each incoming message.
Press MENU/
SELECT when the handset is not in use.
Press
CID or to select Answering Sys, then press MENU/SELECT.
Press
CID or to select Ans sys setup, then press MENU/SELECT.
Press
CID or to select Recording time, then press MENU/SELECT.
Press
CID or to choose from 3 minutes, 2 minutes or 1 minute,
then press
MENU/SELECT VQEQPſTO[QWTUGNGEVKQP;QWYKNNJGCTC
EQPſTOCVKQPVQPG
Announcement
The telephone is preset with a greeting that answers calls with “Hello, please
leave a message after the tone.”
You can use this preset announcement, or
replace it with your own.
Play your announcement
Press MENU/SELECT when the handset is not in use.
Press
CID or to select Answering Sys, then press MENU/SELECT.
Press
MENU/SELECT to select Announcement.
The handset announces,
“To play, press 2. To record, press 7.” Press 2
to play.
Record your own announcement
Press MENU/SELECT when the handset is not in use.
Press
CID or to select Answering Sys, then press MENU/SELECT.
Press
MENU/SELECT to select Announcement.
The handset announces,
“To play, press 2. To record, press 7.” Press 7
to record.
The handset announces, “Record after the tone. Press 5 when you are done.”
After the tone, speak towards the microphone of the handset.
Press 5YJGPſPKUJGF
The answering system automatically plays back the newly recorded
announcement. Press 5 to stop the playback at any time; 2 to replay the
recorded announcement; or 7 to record again if desired.
1.
2.
3.
4.
5.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
8.
Your announcement can be up to 90 seconds in length.
Announcements shorter than two seconds will not be recorded.
•
•