WABCO TEBS E1 - Overview of Functions

TEBS E
4
Introduction
19
4.2 Overview of functions
TEBS E
Modulator
(Standard)
TEBS E
Modulator
(Premium)
TEBS E
Modulator
(Multi-Voltage)
From version:
Basic functions
2S/2M TEBS E0 TEBS E0 TEBS E1.5
4S/2M – TEBS E0 TEBS E1.5
4S/2M+1M – TEBS E0 TEBS E2
4S/3M – TEBS E0 TEBS E2.5
Roll Stability Support (RSS) TEBS E0 TEBS E0 TEBS E1.5
RSS communication in road trains
CAN 5V connection for subsystems (IVTM, Telematics, SmartBoard) TEBS E0 TEBS E0 TEBS E1.5
CAN 5V and power supply on GIO5 (telematics) – TEBS E0 TEBS E1.5
RSS active signal TEBS E0 TEBS E0 TEBS E2
ABS active signals TEBS E0 TEBS E0 TEBS E2
Operation Data Recorder (ODR) TEBS E0 TEBS E0 TEBS E1.5
Speed-dependent functions
Speed signal TEBS E0 TEBS E0 TEBS E2
Speed signal 1 / RTR TEBS E0 TEBS E0 TEBS E2
Speed switch 2 TEBS E1 TEBS E1 TEBS E2
Lifting axle control
Lifting axle (with lifting axle or ECAS valve) Lifting axle valve only TEBS E0 TEBS E2
2 separate lifting axles (with lifting axle or ECAS valve) Lifting axle valve only TEBS E0 TEBS E2
Lifting axle control with LACV-IC – TEBS E2.5 –
Traction help TEBS E0 TEBS E0 TEBS E2
Start traction help by means of reverse gear
Forced lowering TEBS E0 TEBS E0 TEBS E2
Individual forced lowering of lifting axles
OptiTurn (manoeuvering assistance) – TEBS E0 TEBS E2
Start OptiTurn via reversing
OptiLoad (Drawbar load reduction) – TEBS E0 TEBS E2
Traction help ‘off-road’ TEBS E1 TEBS E1 TEBS E2
Forklift control – TEBS E2 TEBS E2
Forklift control on 2 lifting axles (change of the main axle) –
Internal ECAS function
Electronic level control (ECAS 1-point control) – TEBS E0 TEBS E2
Electronic level control ECAS 2-point control with ELEX – TEBS E2 TEBS E2