Safety
6.9 Specific safety instructions for vibration plates
26
Operator’s Manual | APS | 5100060593 | 02/2022 | [en]
6.9.2 Operational safety
• When operating the machine, make sure that no gas, water or elec-
trical lines or pipes are damaged.
• Exercise the utmost degree of caution near abysses or slopes.
Danger of falling!
• Do not leave the designated operating position when the machine is
in operation.
• In trenches and pits, pay maximum attention to side walls so that they
remain stable and do not collapse due to vibration. Risk of spillage!
• Never let the machine run unattended. Risk of injury!
• Keep work area clear and keep unauthorized persons away. Risk of
injury!
• Operators of this machine must ensure that persons staying in the
work area maintain a minimum distance of 2 metres from the running
machine.
• When operating the machine on inclined surfaces, always approach
gradients from below and always stand above the machine on the
slope. The machine could slip or tip over.
6.9.2.1 Safety distances
Compaction work in the vicinity of buildings can lead to building damage.
Therefore, any possible effects and vibrations on surrounding buildings
must be checked in advance.
The relevant regulations and codes of practice for measuring, assessing
and reducing vibration immissions must be observed, in particular DIN
4150-3.
The manufacturer shall not be liable for any damage to buildings.
To Next Page
Loading...
