DPU 130Le 10 Troubleshooting
Operator's manual
94
Malfunction messages on display screen
The last error shall appear temporarily on the display screen each time the
machine is activated. If you have corrected the error the error message in the
diagnostic menu is quit because the error is no longer relevant for further
operation.
In order to quit the last error you must call and exit the diagnostic menu. The
corrected error shall not appear on the display screen any more when the
machine is activated.
Error
code
Display screen Cause Remedy
1 Shutdown
Oil pressure
Engine oil level is too low. 1. Deactivating the machine
2. Top up with engine oil.
Oil pressure switch or electrical
connection is defective.
Have the machine repaired. *
2 Shutdown
Excess temp.
Coolant level is too low. Top up coolant.
Cooling system has a leak. Have the machine repaired. *
Motor is overheated. Let engine cool off.
Radiator cooling fins are dirty. Blow out cooling fins from inside
to outside with compressed air
at a sufficient distance.
Temperature sensor is
defective.
Have the machine repaired.*
Fan wheel is broken. Have the machine repaired.*
V-belt of the fan wheel is
defective or not under sufficient
tension.
Have the machine repaired.*
3 Shutdown
Overvoltage
Charge control or electrical
connection is defective.
Have the machine repaired. *
4Error
Battery
Generator, charge control,
battery, or electrical connection
is defective.
Have the machine repaired. *
5 Shutdown
Charge con./Gen.
Generator, charge control, or
electrical connection is
defective.
Have the machine repaired. *
6Error
Battery
Generator, charge control,
battery, or electrical connection
is defective.
Have the machine repaired. *
7Check
Air cleaner
Air cleaner cartridge is dirty. Change air cleaner cartridge.
Air cleaner sensor electrical
connection is defective.
Check the electrical connection
of the air cleaner sensor. *
To Next Page
Loading...
Need help?
General
