9-14 BA ET18, 20, 24 en* 1.5 * et18_20_24t900.fm
9 Technical data
9.14 Payload/stability
Safety instructions – lift capacity table
The values of the lift capacity table apply to normal operation (for example
excavating).
The values of the stability table apply to lifting gear applications.
Crushing hazard due to tipping over of machine.
Causes serious crushing or injury resulting in death.
► Do not exceed the weight specified in the table (the smallest value
applies).
► Get informed on the lift capacity of the attachment before using it.
► If a bucket or attachment (for example a hammer) is installed, the dead
weight and the contents of the bucket must be subtracted from the
weight specified in the table. Pay attention to the density of the load.
If the specified weight is exceeded, danger of damage to property due to
tipping over of machine.
► Do not exceed the weight specified in the table (the smallest value
applies).
The indications are only approximate values. Attachments, uneven
ground and soft or bad ground conditions affect lift capacity. The operator
must take these influences into account.
To Next Page
Loading...
