BA ET18, 20, 24 en* 1.5 * et18_20_24i400.fm 4-39
Putting into operation 4
4.5 Starting and stopping the engine
Preparations for starting the engine
Set the throttle to the middle position if the engine is cold.
The starter cannot be actuated if the engine is already running (start
repeat interlock).
Do not run the starter for more than 10 seconds.
Wait about 1 minute so the battery can recover and the starter does not
overheat before trying again.
Ensure that there is sufficient ventilation before operating the machine in
small and enclosed areas.
All controls must be within easy reach. You must be able to move the
drive levers to their limit positions.
Starter
Position Function
P Park position Not assigned
0 Stop position Insert or remove the starting key
1 Machine travel position All functions are operational
2 Preheats the engine Preheater active
3 Starts the engine Starter is actuated
To Next Page
Loading...
