BA ET18, 20, 24 en* 1.5 * et18_20_24b500.fm 5-9
Operation 5
5.5 Differential lock
Not available
5.6 Lights/signaling system
Working lights
The switch is located on the control lever base on the left.
Accident hazard due to blinded motorists!
Can cause serious injury or death.
► Switch on the working lights on the job site on public roads only if road
users are not expected to be blinded.
Switch on the working lights (option) in poor light conditions. If illumination
still is not sufficient, use external lights. If this is yet not enough to
illuminate the job site sufficiently, stop machine operation and only start it
again when sufficient illumination can be ensured.
Fig. 126Working light switch
37
Position Function
ON Press switch 37 down
Working lights switched on, the
indicator light in switch 37 illu-
minates
OFF Press switch 37 up
Working lights switched off, the
indicator light in switch 37 goes
out
Fig. 127Working lights
A B C
Position Designation
A Working light (standard)
B Front working lights (option)
B and C Front and rear working lights (option)
To Next Page
Loading...
