4-54 BA E14 track en* 1.3 * E14t_13_400.fm
4 Putting into operation
Starting and stopping the engine
All hydraulic functions are locked if the control lever is raised with a
running engine.
Functional check of control lever base
Before starting work, perform a functional check of the control lever base.
1. Start the vehicle.
2. Fold the control lever base G down.
3. Perform vehicle travel on open terrain.
4. Secure the danger zone.
5. Stop the vehicle.
6. Raise the control lever base G.
7. Move all control levers and pedals in all directions.
➥ The selected elements do not move:
➥ Work may be performed with the vehicle.
➥ The selected elements move:
➥ Stop operation immediately.
Contact a Wacker Neuson service center and have the malfunction
rectified.
Possible damage if the engine is started again immediately after stopping it.
► Wait at least two minutes before starting the engine again.
Possible damage to preheater if the preheating system is operated too long.
► Do not preheat the engine more than five seconds.
Fig. 136 (symbolic representation)
G
Control lever
base
Indication Effect
Raised The engine can be started
Lowered The engine cannot be started
To Next Page
Loading...
