4-20 BA E14 track en* 1.3 * E14t_13_400.fm
4 Putting into operation
Outside rearview mirrors on left and right
• Ensure sufficient visibility from the operator seat onto the job site.
• Ensure maximum visibility to the rear.
• Ensure visibility of the rear left edge of the vehicle in the mirror on the left.
• Ensure visibility of the rear right edge of the vehicle in the mirror on the right.
Upper carriage mirror on the front
• Ensure sufficient visibility from the operator seat onto the job site.
• The area covered by the boom and the area in front of the track on the
right must be visible in the mirror.
• The front edge of the track on the right must be barely visible in the mirror.
Wacker Neuson recommends adjusting the mirrors with two persons.
Do not make any modifications that impair visibility. Otherwise the vehicle
does not meet the requirements for conformity and registration.
• Use safety-oriented ladders and work platforms for adjustment work on
the vehicle.
• Do not use vehicle parts or attachments as a climbing aid.
• Set the boom to travel position before adjusting the mirrors.
Fig. 108 (symbolic representation)
Fig. 109 (symbolic representation)
To Next Page
Loading...
