Maintenance RD 27
92 wc_tx000815gb.fm
9. Flush the cooling system with water until the draining water is transparent.
Filling
Follow the procedure below to fill the cooling system.
1. Close the radiator drain valve.
2. Add the recommended amount of coolant to the radiator.
3. Start the engine.
4. Leave the radiator fill cap off until the thermostat opens and the coolant level
stabilizes.
5. Maintain the coolant level to 2.54 cm (1 in.) below the shoulder of the fill pipe.
6. Inspect the radiator filler cap and filler cap seal for damage. Clean the radiator
filler cap or replace it if necessary.
7. Re-install the radiator filler cap.
To Next Page
Loading...