10 Maintenance
28 100_0202_mt_0016.fm
Clean the machine
1. After cleaning, check the cable, hoses, utility lines and hardware for leaks, loose connections, chafe
marks and other damage.
2. Immediately eliminate detected damage.
Screwed connections
For the vibratory plates, the screwed connections must be regularly checked for a firm seat.
Check engine oil level
1. Check the oil level on the oil-level dipstick and top off if necessary. For the motor oil type, see chapter
Technical Data.
Replace motor oil
WARNING
Risk of fire and explosion when using flammable cleaning agents.
Do not clean the machine and elements with gasoline or other solvents.
NOTICE
Penetrating water can damage the engine, electrical operator's controls or components of
the machine. Do not aim high pressure washer directly at air intake area and electrical
elements.
NOTICE
The machine needs to be decommissioned and level when checking the oil level and
changing the oil.
DANGER
Risk of scalding
Use caution when draining hot oil.
WP VP
Item Designation
1 Oil-level dipstick / filler neck
NOTICE
Drain the oil when the engine is still warm.
To Next Page
Loading...
Need help?
General
