62
62
Index
Contents
IndexContents
Changing the function settings
of an input tool has no effect.
Make sure you change the settings for the tool and the application that
you are using. See working with multiple tools
and application-specific
settings.
The pen side switch does not
work.
Be sure you are using the pen that originally came with Intuos4 or an
Intuos4 accessory pen. Other pens may not function properly on the
tablet.
Be sure to press the side switch when the pen tip is within 10 mm
(0.39 inch) of the tablet’s active area – do this without pressing down on
the pen tip.
In the Wacom Tablet control panel, verify that the side switch is set to the
function you are expecting to occur for the application and tool you are
using.
Check also the S
IDE SWITCH MODE. If CLICK & TAP is selected, you will
need to first press the side switch while touching the pen tip to the tablet
surface in order to perform a click function. See customizing tool
buttons.
Make sure a tablet status LED brightens when you press the side switch.
If not, you may have defective hardware. See testing your tools
.
The screen cursor jumps back. Do not place an Intuos4 tool on the tablet when it is not in use, or when
you are using another pointing device. Leaving your tool on the tablet
may interfere with screen cursor positioning when using other input
devices.
Cannot move the cursor where
you want to on the screen, or
the line you are drawing does
not line up with the location of
the pointer in paint
applications.
Open the Wacom Tablet control panel and go to the M
APPING tab.
Verify that P
EN mode is selected and that the SCREEN AREA is set to FULL
for the selected tool and application. If this does not help, click on the
D
EFAULT button to reestablish tablet to screen mapping. If you are still
having difficulty, remove the tablet preferences (see next tip).
To Next Page
Loading...
Need help?
General
