157
PXM
Do not change the document or the safety relevant information without approval of the MACHINERY expert
Declaration of Incorporation
Powder center – PXM-ITA
Issued
PXM-ITA R0
04/05/2015
Approved
Mach Expert
sheet 2 of 2
H.B. S.a.s. di Luigi Volonte’ e C. – Via Carlo Porta, 13 - 23861 Cesana Brianza (LC)
ATEX conformity assessment procedure has been executed according to Annex VIII of European
Directive 94/9/EC producing the following technical file,
serial.as4
The ATEX marking is the following: II 3/-D T85°C IP54 -0°C≤Tamb≤+40°C
MACHINERY conformity assessment procedure has been executed according to Annex VIII of
European Directive 2006/42/EC producing the following technical file,
serial.as4
EMC conformity assessment procedure has been executed according to Annex II of European
Directive 2004/108/EC producing the following technical file,
serial.as4
Low voltage conformity assessment procedure has been executed according to Annex IV of
European Directive 2006/95/EC producing the following technical file,
serial.as4
We hereby declare that the person authorized to
assemble the Machinery technical file is:
Luigi Volontè
Address: Via Carlo Porta, 13
Cesana Brianza (LC) - Italy
Essential health and safety requirements that are not met and are on charge to the user
With reference to Annex I of Directive 2006/42/EC shows the Essential Health and Safety are in part or
entirely on charge to the installer and user. Installer and user are invited to take charge of the resolution of
open points before operation of the machine.
1.1.4 Lighting
1.1.7. Operating positions
1.2.4.1. Normal Stop
1.2.4.4. Assembly of machinery
1.2.5. Selection of control or operating modes
1.2.6. Failure of the power supply
1.5.6. Fire
1.5.16 Lightning
This partly completed machinery must not be put into service until the final machinery into which it
is to be incorporated has been declared in conformity with the provisions of this Directive.
Cesana Brianza, XX/XX/XXXX Luigi Volontè
CEO
OPERATING AND ASSEMBLY MANUAL
VERSION 08/2015 ORDER NUMBER DOC2350372
To Next Page
Loading...
Need help?
General
