55
EDITION 08/2021
ORDER NUMBER DOC241936
IP 5000
2
P_04338
3
4
1
8. Fit lower valve housing (2) and Y-piece (3) to the bottom of the pump body (1) and
fasten with screws (4).
9. Evenly tighten screws (4) alternately crosswise. (6 Nm; 4.43 lb ft).
Installation instructions:
To facilitate assembly, two longer screws (order no. 9907014) can be used, which
must be replaced with the shorter screws when assembly is complete.
10. Push powder hoses onto the lower hose tting and fasten with hose clips.
11. Insert air lines into the lower valve blocks.
12. After successful execution of the tightness check, the powder pump can be
recommissioned.
To Next Page
Loading...
