Walker C23i - Recommendations for Mowing

C23i Operating Instructions
41
3. The mower will “freewheel” with the arms in
the LOCKOUT position. The levers must be in
the highest position to completely unlock the
transaxles.
9804-1
Transaxle Lockout Arm
Transaxle Lockout Arm - Freewheel Position
4. After moving the mower, release the arms,
placing them down in the normal OPERATING
position. The transaxle lockout arm ends
should be completely retracted against the
chassis, otherwise operation of the transaxle
may be erratic.
9804-1
Transaxle Lockout Arm
Transaxle Lockout Arm - Normal Operating
Position
RECOMMENDATIONS FOR MOWING
DANGER
Do not mow around overhanging tree
branches or bushes at the same height as
the operator’s torso and head where inad-
vertent contact may cause injury.
Avoid Low Hanging Branches
IMPORTANT: Operate the engine at full throttle
when mowing, to allow the engine to produce full
horsepower and to increase e󰀩ciency of the
engine cooling system.
● Keep the mower deck and discharge chute
clean.
● Mow with sharp blades. A dull blade tears the
grass (resulting in poor lawn appearance) and
uses extra power (slowing the mowing speed).
● It is preferable to cut grass when it is dry and
not too tall. Mow frequently and do not cut
grass too short. (For best appearance, cut o󰀨
1/3 or less of existing grass height.)