EasyManua.ls Logo

Wallenstein FX Series - Safety Label Explanations

Wallenstein FX Series
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Labels
FX85, FX110, FX140
Skidding Winch
Safety
14
3.2 Safety Label Explanations
1. Warning!
Entanglement hazard
Hands, feet, clothing, hair, jewelry, and
other items can get entangled in the PTO
shaft and cause serious injury or death.
Stay away from the PTO shaft when it is
turning.
2. Caution!
Read the Operator's Manual
There is important safety information and
instructions in the Operator's Manual.
Read all the safety information and
instructions in the Operator's Manual.
Know what all the safety labels mean.
3. Warning!
Entanglement and pinch hazards
Hands, feet, clothing, hair, jewelry, and
other items can get entangled in the PTO
shaft and cause serious injury or death.
Disconnect the PTO shaft from the
tractor before you start service or
maintenance.
4. Warning!
Carcinogen and
reproductive harm hazard
The machine materials
contain chemicals or
machine operation can
produce gases or dust that
are identified by the state
of California as causes of
cancer, birth defects, or
other reproductive harm.
This warning is a
requirement of the state of
California, USA to comply
with Proposition 65: the Safe
Drinking Water and Toxic
Enforcement Act of 1986.
5. Warning!
High-pressure injection hazard
Injection of hydraulic fluid can cause
serious illness, injury, or death.
FX-R and FX-RS models have a
concealed hydraulic fluid connection.
Hydraulic fluid is under pressure. Use
caution when removing a guard or panel.
If you think there is a hydraulic fluid leak,
move away from the area. Do not use
your hands to check for hydraulic fluid
leaks. Wear the correct hand and eye
protection, and always use a piece of
cardboard, wood, or plastic to find a leak.
6. Warning!
Crush hazard
Keep the cable or winch rope as straight as
possible. Never operate the machine with
the cable or winch rope at an angle greater
than 25° from the center of the machine (in
either direction).
If necessary, use a self-releasing
directional pulley. Self-releasing directional
pulleys are available to purchase through
your Wallenstein dealer or distributor.

Table of Contents

Other manuals for Wallenstein FX Series

Related product manuals