WANHAO DUPLICATOR 9 - Resuming after power failur

Installation
If you encounter a power failure, for any reasons such as power outage or accidentally cut the
power cord during printing. Don't worry, D9 comes with printing resume feature. After power
intrupption you can power on the printer and select [Continue] and you can proceed with the
unnished model.
Resuming after power failur
NOTE: For resume printing Don't move the nozzle until the printer proceed for print,
otherwise the printing postion would not be as accurate as it should be. Wait for the
nozzle to be heated, and do not touch the nozzle with your hand, which may cause you
to burn.
25
AFTER SALES SUPPORT
86-571-23290996
support@wanhao3dprinter.com
Model : Duplicator 9