WANHAO DUPLICATOR I3 MINI - Filament and Material Information; 4.7 Filament; 4.7.1 PLA filament

24
SETUP
4.7 Filament
The WANHAO Duplicator I3 Mini is designed to be only used with PLA(Polylactic Acid BioPlastic)
alment.Only use genuine WANHAO laments as using generic laments may damage your 3D
printer and may void your warranty. Extra lament including multiple colours and PLA types are
availabe from the online store at
id.aliexpress.com/store/120824V
4.7.1 PLA lament
Extruder Temp: 215
°C
Ofcial Name: Polyactic Acid
Printing Level: Basic
Advantages: * Bioplastic
* Non-Toxic
* Less warping issues
* Hard or soft/exible variants
* High print speed
Disadvantages: * Low heat resistance
* Easier break than ABS
* Requires thicker walls than ABS
Finishing: * Sanding possible
* Limited gluing