26
SETUP
4.9.4 Adding your Duplicator I3 Mini to Cura
On rst launch,Cura will ask you to add a 3D printer from the list provided.Alternatively,you
can add a 3D printer by selecting Machine Machine settings Add new Machine
1. Select Other
2. Select Custom...
3. Enter Machine name as 'Duplicator I3 Mini', or your desired name
4. Input Machine width as 120mm
5. Input Machine depth as 135mm
6. Input Machine height as 100mm
7. Change Nozzle size to 0.4mm
8. Ensure heated print bed is Not ticked
9. Select'Finish'
For the latest optimized/recommended Cura settings for your Duplicator I3 Mini,Visit
www.wanhao3dprinter.con
1. Clear the platform using File clear platform...
2. Then, load your 3D design le onto the platform using File Load model le...
3. Load any le with the following extensions: .STL, .OBJ, .DAE,.AMF
TIP : You can load more than one le onto the platform.Cura will automatically move the
additional les to t
NOTE: Files in grey are outside of the print area and need to be moved or scaled to t.
4.9.5 Loading a 3D design into Cura
To Next Page
Loading...
